Table of Contents
Advertisement
24
AutoView 200/400 Installer/User Guide
Administrator Commands Features List
Command
Add Channel
Edit Channel
Delete Channel
Administrator Functions
Scanning
Setup Scan List
Reset PS/2 Standard Mse/Kbd Reset the mouse and keyboard to restore correct settings.
Reset PS/2 Wheel Mse/Kbd
Version Information
To access the Administrator Commands menu:
1.
Press the keyboard Control key twice within one second.
2.
In non-secure mode, the Administrator Channel List appears.
-or-
In secure mode, the User Login window appears. Type in your
user name and press Enter. The Administrator Channel List appears.
-or-
In secure mode, if you are the system administrator, log in as Admin, Root
or Administrator. Type your password and press Enter. The Administrator
Channel List appears.
3.
Press the keyboard Control key twice within one second again. The
Administrator Commands menu appears.
4.
Press the Up or Down Arrow keys to select a specifi c menu or command.
5.
Press Enter to access a screen or activate a command.
-or-
Press Escape to exit the window without saving changes.
Adding and maintaining channels
You may add, edit or delete a channel whenever you want to change your
AutoView system. You will have the ability to name the channel, set the port
address, set the time that the channel ID will flash on the screen and establish
the scan dwell time if appropriate.
To add a new channel:
1.
Press the keyboard Control key twice within one second. The
Administrator Channel List appears.
Description
Set up the channel name, address, ID and scan dwell times.
Edit the channel name, address, ID and scan dwell times.
Delete a channel from the Administrator Channel List.
Set up administrator, users, channel switching, port setup
and FLASH upgrade.
Initiate the mode where the switch scans from port to port.
Set up a custom scan pattern (AutoView 400 only).
Reset the mouse and keyboard to restore correct settings.
Access the version information about your system.
Advertisement
Table of Contents
