Canon LBP 5300 User Manual page 426

Cause 4 Data was sent before completing calibration, such as when the printer was first
turned ON.
Remedy Make sure that calibration is completed before sending data to the printer.
NOTE
• When you select [Print Priority] from [Operation Immediately after Power ON] in
[Calibration Settings] in [Device Settings] in the [Options] menu in the Printer Status
Window, calibration will be performed at the completion of the first printing after the
printer is turned ON. (See "Performing Calibration Immediately after the Printer is Turned
ON," on p. 6-21)
• If you want to perform calibration manually, see "Performing Calibration Manually," on p.
6-18.
The colors of thin lines or filled-in patterns are different from the specified colors, or do not
appear at all.
Cause 1 Some colors cannot be reproduced due to the combination of colors or
patterns.
Remedy 1 Adjust the colors in the application and print again.
Remedy 2 Change the patterns in the application and print again.
Cause 2 The color may appear different depending on the fill-pattern.
Remedy 1 Readjust to a darker color and print again.
Remedy 2 Reload paper to change the feeding direction, then print again.
Fill-patterns are not printed in the correct color (specified color).
Cause The fill-pattern of the print data and the dither pattern of the printer are
interfering with one another.
Remedy 1 Print again without specifying a fill-pattern in the application.
Remedy 2 Set [Color Halftones] or [B & W Halftones] to [Gradation] or [Color Tone] in the
printer driver.
In order to specify the setting for [Color Halftones] or [B & W Halftones], display
the [Custom Settings] dialog box by clicking [Settings] in the [Quality] sheet .
Print Quality Problems
7
7-45