Canon LBP 5300 User Manual page 419

Cause 2
Remedy
Cause 3
Remedy
Residual images appear on non-printed areas.
Cause 1
Remedy
Cause 2
Remedy
Cause 3
7
Remedy
Cause 4
Remedy
The overall print result is faint.
Cause 1
Remedy
Cause 2
Remedy
7-38 Print Quality Problems
Paper is damp since the paper has been stored in unsuitable condition.
Replace the paper with new one and print again. (See "Paper Requirements,"
on p. 3-2)
The drum in any of the toner cartridges has deteriorated.
Replace the toner cartridge with a new one. (See "Replacing Toner Cartridges,"
on p. 6-2)
Printing paper is inappropriate.
Change the paper and print again. (See "Paper Requirements," on p. 3-2)
Paper with a glossy surface was printed.
Set [Special Print Mode] to [Special Settings 3] in the printer driver. If this solves
the problem, set [Special Print Mode] to [Off].
In order to specify the setting for [Special Print Mode], display the [Advanced
Settings] dialog box by clicking [Finishing Details] in the [Finishing] sheet, and
then clicking [Advanced Settings] in the [Finishing Details] dialog box.
Residual images appear depending on the printer status.
Set [Special Print Mode] to [Special Settings 8] in the printer driver. If this solves
the problem, set [Special Print Mode] to [Off].
In order to specify the setting for [Special Print Mode], display the [Advanced
Settings] dialog box by clicking [Finishing Details] in the [Finishing] sheet, and
then clicking [Advanced Settings] in the [Finishing Details] dialog box.
The drum in any of the toner cartridges has deteriorated.
Replace the toner cartridge with a new one. (See "Replacing Toner Cartridges,"
on p. 6-2)
The setting for [Toner Density] is not appropriate.
Drag the [Toner Density] slider in the printer driver toward [Dark].
In order to specify the setting for [Toner Density], display the [Custom Settings]
dialog box by clicking [Settings] in the [Quality] sheet.
[Toner Save] is enabled.
Clear the [Toner Save] check box in the printer driver.
In order to specify the setting for [Toner Save], display the [Custom Settings]
dialog box by clicking [Settings] in the [Quality] sheet.