Remote Power Amplifier Control Output; Bridging; Break-In Period; Programmable Input Selections - Halcro DM8 Owner's Manual

dm8

Remote Power Amplifier control Output

The dm10 has a remote power amplifier control output (fig 6,15) which will remotely switch
the HALCRO™ amplifiers from Standby to On. Cables can be purchased through HALCRO™
for details please email us at:

Bridging

The dm8 will control bridged power amplifiers. For details please email us at:
service@halcro.com A bridging kit can be purchased through HALCRO™.

Break-in period

The dm8 does not require a break-in period. The electronic break-in period is completed at the
factory.

Programmable Input Selections

The dm8 has seven available pairs of programmable input connectors, three unbalanced, three
balanced voltage inputs and one unbalanced current input. All inputs that have a signal
source connected must be programmed by the remote control. Any input can be programmed
to connect any source. Each button on the remote control can have only one signal source
programmed to it at any time.
Input
Modes
Unbalanced current
input
Balanced voltage input
Unbalanced voltage
input
service@halcro.com .
Required output
source impedance
RCA: Infinite source
impedance
XLR: Low source
impedance
RCA: Low source
impedance
Input impedance
50ohm input impedance
10kohm + 10kohm input
impedance
10kohm input impedance
Page 14 of 26
TM