Switching The Unit On; Allocating Signal Sources And The Remote Control; De-Allocating Program Buttons - Halcro DM8 Owner's Manual

dm8
TM

Switching the unit on

Switch the main power switch to On.
When the unit is switched on at the main power switch (Fig 6, 6) the pre- amplifier will go into
Standby mode.
Switch the unit on by pressing the Standby/On button on the unit or the remote control. To
return the unit to Standby mode press the Standby/On button again.
Note: To continue the set up process, the unit must be On, not in Standby.

Allocating signal sources and the remote control

All inputs must be allocated using the remote control (Fig 7). Note: The Phono selection is
permanently allocated to the Phono inputs.
Once the signal source units (e.g. CD player) have been connected to the input connector
terminals (Fig 6, 7) at the rear of the preamplifier, ensure that the preamplifier is On, not in
Standby mode.
Depress the applicable program button (situated above the connectors) and simultaneously
point the remote control to a remote sensor window and press the button on the remote control
which best describes the signal source unit you have connected.
The program button will flash twice and will remain illuminated, indicating that this pair of
input connectors are now allocated to the selected signal source unit. Repeat this process for
all signal source units (maximum 5 plus Phono).
If the device label that is being depressed on the remote control has been previously allocated
to another connector pair, this pair will now be de-allocated.

De-allocating Program Buttons

Note: Ensure the location being de-allocated is not the currently selected input, the currently
selected input can not be de-allocated.
Press and hold the applicable program button and simultaneously point the remote control to
a remote sensor window and press the Mute button. The Program Button will flash twice and
then remain off. This input has now been de-allocated and can be used for another signal
source unit.
Page 16 of 26