Universal Garage Door Opener (Homelink ® ) - RAM 1500 2012 User Manual

Auto Unlock Doors On Exit
• To have all of the vehicle doors unlock when any door is opened:
• Enter your vehicle, close all the doors and fasten your seat belt.
• Within 15 seconds, cycle the ignition switch from the OFF position to the ON
position a minimum of four times, ending in the OFF position (do not start the
engine).
• Within 30 seconds, press the driver's door lock switch in the UNLOCK
direction. A single chime will indicate that programming is complete.
Sound Horn With Lock
• To turn the horn chirp on or off when the doors are locked:
• Press the LOCK button for at least 4 seconds, but no longer than 10 seconds.
Then, press the PANIC button while still holding the LOCK button.
• Release both buttons at the same time.
Flash Lamps With Lock
• The turn signal lights flashing feature, when the doors are locked or unlocked,
can be turned on or off. To turn this feature on or off:
• Press and hold the UNLOCK button for at least 4 seconds, but no longer than
10 seconds. Then, press and hold the LOCK button while still holding the
UNLOCK button.
• Release both buttons at the same time.
UNIVERSAL GARAGE DOOR OPENER (HomeLink
• HomeLink ® replaces up to three hand-held transmitters that operate devices
such as garage door openers, motorized gates, lighting or home security
systems. The HomeLink
• The HomeLink
designate the three different HomeLink
• The HomeLink
Before You Begin Programming
HomeLink ®
• Be sure that your vehicle is parked
outside of the garage before you
begin programming.
• For more efficient programming and
accurate transmission of the
radio-frequency signal it is
recommended that a new battery be
placed in the hand-held transmitter
of the device that is being
programmed to the HomeLink
system.
unit is powered by your vehicles 12 Volt battery.
®
® buttons that are located in the overhead console or sunvisor
® indicator is located above the center button.
®
ELECTRONICS
)
®
® channels.
69