Parkview ® Rear Back-Up Camera; Tire Pressure Monitor System (Tpms) - 2500 Models Only - RAM 1500 2012 User Manual

Guts-glory trucks
Hide thumbs Also See for Ram 1500 2012:
Table of Contents

Advertisement

OPERATING YOUR VEHICLE
PARKVIEW
REAR BACK-UP CAMERA
®
• You can see an on-screen image of the rear of your vehicle whenever the shift
lever is put into REVERSE. The ParkView
be displayed on the radio display screen, located on the center stack of the
instrument panel.
• If the radio display screen appears foggy, clean the camera lens located on the
tailgate.
Drivers must be careful when backing up even when using the ParkView
Back-Up Camera. Always check carefully behind your vehicle, and be sure to
check for pedestrians, animals, other vehicles, obstructions, or blind spots
before backing up. You must continue to pay attention while backing up. Failure
to do so can result in serious injury or death.
TIRE PRESSURE MONITOR SYSTEM (TPMS) – 2500 MODELS ONLY
Tire Light Load Inflation Switch Description
• The Tire Pressure Monitoring System on your vehicle has two different tire
pressure settings based on vehicle loading. The Tire Light Load Switch is
located on the Instrument Panel above the climate controls.
• The "Light Load Inflation" and "Max Load Inflation" tire pressures
recommended for your vehicle based on vehicle loading are found on the
Supplemental Tire Pressure Information Label located on the rear face of the
driver front door.
• When the vehicle is in the "Light Load Inflation" setting, the Tire Light Load
Inflation switch is On. The indicator light is Off when in the "Max Load
Inflation" setting.
Light Load Inflation (Indicator Light On)
• If the passenger and cargo weights are less than the Light Load Pressure
Definition shown on the Supplemental Tire Pressure Information Label, inflate
or deflate tires to the correct "Light Load Inflation" pressure. If the indicator
light is not on, the mode can be changed by pushing the switch once.
• If the light on the switch flashes On and Off, after the button is pressed to
switch between modes, this indicates conditions are not correct to switch
modes. The system will not allow switching modes until the tire pressures
have been set to Light Load Inflation as indicated on the Supplemental Tire
Pressure Information Label.
• IF THE LIGHT STARTS FLASHING TO SHOW LOW AIR PRESSURE, BRING
THE AIR PRESSURE IN THAT TIRE TO THE PLACARD VALUE SHOWN ON
THE LABEL ON THE DRIVER DOOR. NOTE: AFTER INFLATION, THE
VEHICLE MAY NEED TO BE DRIVEN FOR UP TO 20 MINUTES BEFORE THE
FLASHING LIGHT WILL GO OFF.
28
®
Rear Back-Up Camera image will
WARNING!
®
Rear

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents