Advertisement
USE
Button
Function
A
Motor off.
Enables / Disables Keyboard Lock mode if pressed
and held for 5 seconds.
B
Activates speed one.
C
Activates speed two.
D
Activates speed three.
Press and hold the button for approximately 5
seconds, with all the loads turned off (Motor and
Lights), to turn the Activated Charcoal Filter alarm
on.
To turn it off, press and hold the button again for 5
seconds.
E
Activates speed four.
Press and hold for 5 sec. to activate Intensive
speed. This speed is timed to run for 10 minutes. At
the end of this time the system will return to the
speed set previously.
It is disabled by pressing the Button or turning the
Motor off.
F
Starts the 24H function, in which the motor starts at
a speed that allows suction of 100 m3/h for 10
minutes per hour. This mode cannot be activated if
Intensive or Delay modes are active.
To deactivate it, press the same button or button A.
When the filters alarm is triggered, the alarm can be
reset by pressing and holding this button for
approximately 5 seconds. These indications are
only visible when the motor is turned off.
G
Activates
Delay
shutdown of the Motor and the Lighting system
with a 20' delay.
It is disabled by pressing the button or turning the
motor off.
Pressing and holding the button for 5 seconds
enables the remote control.
Pressing and holding the button for 5 seconds
disables the remote control
H
Press briefly to turn the lighting system on and off
at maximum intensity.
Press and hold the button for 2 seconds to turn the
Courtesy Lights On (if provided).
EN
Control panel
mode,
causing
automatic
Led
The Leds indicating the Speed of the motor turn off.
All the Leds light up in cycle and run a start-up sequence.
The Leds indicating Speed one and Motor Off turn on.
The Leds indicating Speed two and Motor Off turn on.
The Leds indicating Speed three and Motor Off turn on.
Button A LED flashes twice.
Button A LED flashes once.
The Leds indicating Speed four and Motor Off turn on.
The Led flashes once a second and button A Led lights up.
The Leds indicating 24H speed and Motor Off turn on.
24H Led Flashing:
Indicates the need to wash the metal grease filters. The alarm is
triggered after the Hood has been in operation for 100 working
hours.
The button A Led flashes three times
The Delay and Motor Off button Leds turn on.
Delay Led Flashing:
Indicates the need to change the activated charcoal filters, and
also to wash the metal grease filters. The alarm is triggered after
the Hood has been in operation for 200 working hours.
Button A Led flashes twice.
Button A Led flashes once.
The Led on the button lights up.
The Led on the button lights up.
9 9
Advertisement
