Table of Contents
Advertisement
SpECIAL SETTINGS
Note:
You can abort the search by pressing »
7
i
9 Press »
« to end the setting.
Searching for digital terrestrial
TV channels manually
1 Open the menu with »i«.
2 Select the line »SOURCE SETUP« with »
or »
« and press »●« to confirm.
Λ
– T he »SOURCE SETUP« menu appears.
3 Select the line »Source« with »
and press »●« to confirm.
Select the option »Air« with »
»
« and press »●« to confirm.
Λ
Caution:
The antenna power supply (line »Active
7
Antenna Power«) may only be switched on
if the antenna is an active indoor antenna
with a signal amplifier and it is not already
supplied with a voltage via a mains plug
(or similar supply). Otherwise you may
cause a short circuit and irreparably dam-
age your antenna.
4 Select the »Active Antenna Power«« with »
or »
«. Switch on the antenna power supply
Λ
for the antenna with »
5 Select » Digital Manual Tuning« with »
»
« and press »●« to confirm.
Λ
– T he menu appears.
6 Enter the channel number directly with
»
« and press »●« to confirm.
1 ... 0
– A fter the search is complete, the channels
found are displayed in the »Results« menu.
i
7 Press »
« to finish the setting.
----------------------------------------------------------------------------------------------------------
i
«.
V
« or »
V
Λ
<
>
«, »
«, »
« or
V
V
<
>
« or »
« (»On«).
« or
V
Tuning analogue television
channels
This setting is only necessary if you cannot re-
ceive any digital channels and you have not car-
ried out an analogue search during initial setup.
The television channels can be set directly or
using the scan.
Switching the television to
«
analogue reception
Note:
«
Analogue channels can be selected if the
7
option »Air« or »Cable« has been selected.
1 Open the »Select input source« menu with
»AV«.
2 Depending on the antenna system, select the
option »Air« or »Cable« with »
>
or »
« as the input source and press »●« to
confirm.
Note:
Additional operations are explained in the
7
following sections.
Setting all analogue television
«
channels
Analogue channels are displayed in the channel
list after the digital channels.
Note:
Plug the rooftop antenna cable (for analogue
7
television channels) into the
socket on the television.
1 Open the menu with »i«.
2 Select the line »SOURCE SETUP« with »
or »
« and press »●« to confirm.
Λ
– T he »SOURCE SETUP« menu appears.
3 Select the line »Source« with »
and press »●« to confirm.
Select the option »Air« or »Cable« with »
>
»
«, »
« or »
V
4 Select the line »Automatic Channel Search«
with »
« or »
V
«, »
V
»ANT
« or »
V
« and press »●« to confirm.
Λ
« and press »●« to confirm.
Λ
ENGLISH
<
«, »
«
Λ
IN«
«
V
«
Λ
<
«,
65
Advertisement
Table of Contents
