Advertisement
XPress LED™
The XPress LED™ carries a three year (1095 days) limited warranty.
Please fill out the enclosed warranty card to validate your purchase.
All returned service items whether under warranty or not, must be
freight pre-paid and accompany a return authorization (R.A.) number.
If the unit is under warranty you must provide a copy of your proof of
purchase invoice. Please contact American DJ
a R.A. number.
XPress LED™
Safety Issue:
This unit may blow the fuse if the maximum allotted
load of 6 amps is reached. If the fuse needs replacement, please see
fuse replacement on page 5.
• Be sure the local power outlet match the required voltage of the
unit.
• Disconnect from main power before making any type of connection.
• Do not remove the cover under any conditions. There are no
user serviceable parts inside.
• Always be sure to mount this unit in an area that will allow proper
ventilation. Allow about 6" (15cm) between this device and a wall.
• To reduce the risk of electrical shock or fire, do not expose this unit
rain or moisture
• This unit is intended for indoor use only, use of this product out-
doors voids all warranties.
• During long periods of non-use, disconnect the unit's main power.
• Always mount this unit in safe and stable matter.
• Power-Cord Protection - Power-supply cords should be routed
so that they are not likely to be walked on or pinched by items
placed upon or against them, paying particular attention to cords at
plugs, convenience receptacles, and the point where they exit from
the fixture. Do not attempt to remove or break off the ground prong
from the electrical cord. This prong is used to reduce the risk of
electrical shock and fire in case of an internal short.
• The fixture should be serviced by qualified service personnel when:
A. The power cord or the plug has been damaged.
B. Objects have fallen, or liquid has been spilled into the appliance.
C. The appliance has been exposed to rain or water.
D. The fixture does not appear to operate normally or exhibits a
marked change in performance.
American DJ Supply
- www.americandj.com - XPress LED™ Instruction Manual Page 3
©
®
Warranty Registration
customer support for
®
Precautions
XPress LED™
Introduction:
The American DJ
moon-flower effect. This fixture is designed for mobile DJ's, clubs,
bands, roller rinks and any arena that requires a compact, light weight,
easy to use unit.
Power Supply:
Before plugging your unit in, be sure the source volt-
age in your area matches the required voltage for your American DJ
XPress LED™ before attempting operation.
Operation:
This fixture is designed to operate as a stand alone
sound active unit, there is no need of a controller. It has been tested
and there is no assembly necessary. The XPress LED™ is ready to be
plugged in out of the box, there is no power switch. When this fixture
is plugged in, the unit will start to project preset designs to the sound
of an audio source via an internal microphone. The audio sensitivity is
preset at the factory for optimum performance and is not user adjust-
able.
After plugging the unit if there is no LED output check the fuse. If the
fuse has not popped, please contact customer support for further
instructions. This fixture features a light weight case design and an
adjustable hanging bracket.
XPress LED™
With this feature you can connect the fixtures to one another
using the IEC input and output sockets. The quantity that can be
connected is 19 fixtures maximum. After 19 fixtures you will need
to use a new power outlet. They must be the same fixtures. DO
NOT mix fixtures.
American DJ Supply
- www.americandj.com - XPress LED™ Instruction Manual Page 4
©
®
Operation
XPress L
is a sound active LED
ED™
®
Operation
®
Advertisement
