Installation - Alpine TDM-7590R Owner's Manual

Installation

Caution
When you install this unit in your car, do not remove
the Detachable Front Panel.
If the Detachable Front Panel is removed during
installation, you might press too hard and warp the
metal plate that holds it in place.
1
Bracket
Dashboard
Mounting sleeve
(Included)
Remove the Detachable Front Panel (refer to
page 5). Slide mounting sleeve from main unit
(see Removal Procedure below). Slide the
mounting sleeve into the dashboard.
2
Metal Mounting Strap
Hex Nut (M5)
When your vehicle has the Bracket, mount the long
hex bolt onto the rear panel of the TDM-7590R
and put the Rubber Cap on the hex bolt. If your
vehicle does not have the Mounting Support,
reinforce the head unit with the metal mounting
strap (not supplied). Connect all the leads of the
TDM-7590R according to details described in the
CONNECTIONS section.
NOTE
For the screw ∗, provide a proper screw to the chassis
installing location.
Metal plate
Detachable
Front panel
Rubber Cap
(Included)
Hex Bolt
(Included)
TDM-7590R
Screw
Bolt Stud
∗
TDM-7590R
3
Slide the TDM-7590R into the dashboard. When
the unit is in place, make sure the locking pins are
fully seated in the down position. This can be done
by pressing firmly in on the unit while pushing the
locking pin down with a small screwdriver. This
ensures that the unit is properly locked and will not
accidentally come out from the dashboard. Install
the Detachable Front Panel.
Lock pin
Removal
1 Remove the detachable front panel.
2 Use a small screwdriver (or similar tool) to
push the locking pins to the "up" position (see
above drawing). As each pin is unlocked, gently
pull out on the unit to make sure it does not re-
lock before unlocking the second pin.
3 Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
Front frame
TDM-7590R
Screws (M5 × 8)
(Included)
Mounting Bracket
23
-EN