Basic Operation; Detaching The Front Panel; Attaching The Front Panel; Initial System Start-Up - Alpine TDA-7592R Owner's Manual

Basic

Basic Operation

Detaching the Front Panel

1
Press and hold the POWER button at least 3
seconds to turn off the power.
2
Press the
the front panel pops out.
3
Grasp the left side of the front panel and pull it
out.
NOTES
• The front panel may become hot in normal usage
(especially the connector terminals on the back of the
front panel), this is not malfunction.
• To protect the front panel, place it in the supplied
carrying case.

Attaching the Front Panel

1
First, insert the right side of the front panel into
the main unit. Align the groove on the front panel
with the projections on the main unit.
2
Push the left side of the front panel until it locks
firmly into the main unit.
NOTE
Before attaching the front panel, make sure that there is
no dirt or dust on the connector terminals and no foreign
object between the front panel and the main unit.
4
-EN
POWER MODE/BBE
(Release) button at left side until
2
1 1
RESET
ANGLE 89
• Compatibility with Factory Steering Wheel
Radio Controls
If your vehicle has steering wheel controls for
the radio, an optional steering wheel control
interface may be available to connect your
Alpine radio. For details, contact your Alpine
dealer.

Initial System Start-Up

Immediately after installing or applying power to the
unit, it should be initialized. Press the RESET switch
with a ballpoint pen or any other pointed object.
About Demonstration
This unit is equipped a Demonstration function.
Soon after resetting the unit or after turning the
unit on the first time, the demonstration starts
automatically.
To cancel the demonstration, refer to
"Demonstration" on page 10.