Adjusting Source Signal Level; Changing Backlighting Colour - Alpine TDA-7592R Owner's Manual

Basic
g DN
Basic Operation

Adjusting Source Signal Level

If the difference in volume level between the CD
player and FM radio is too great, adjust the FM
signal level as follows.
1
Press and hold the SETUP button for at least 3
seconds.
2
Press the f UP button repeatedly to select
"FM-LV."
Each press of the f UP button scrolls the
modes as follows:
→ FM-LV → REG → PTY31 → HI-FI/NORMAL/STABLE → AMBER
DEMO ← AUX ← SCR ← MUTE ← BEEP ← SUB ← DIM ←
NOTE
When you press the g DN button, the display scrolls
in the reverse sequence.
3
Press the TUNE button to select the FM signal
level mode. Each press toggles between "FM-LV
HI" (High) and "FM-LV LO" (Low).
4
Press the SETUP button to activate the normal
mode.
6
-EN
TUNE MODE
f UP SETUP

Changing Backlighting Colour

1
Press and hold the SETUP button for at least 3
seconds.
2
Press the f UP button repeatedly to select
"AMBER".
Each press of the f UP button changes the
modes as shown:
NOTE
If you press the g DN button the display scrolls in
reverse sequence.
→ FM-LV → REG → PTY31 → HI-FI/NORMAL/STABLE → AMBER
DEMO ← AUX ← SCR ← MUTE ← BEEP ← SUB ← DIM ←
3
Press the TUNE button to toggle the mode
between "AMBER ON" (amber) and "AMBER
OFF" (green).
4
Press the SETUP button to set the selected
mode.