Brother DCP-9010CN User Manual page 75

Error Message
Print Unable XX
(XX=Error Code)
Print Unable 1A
Registration
Replace Belt
Replace Drums
1
Replace Drum(X)
Replace Fuser
Replace PF Kit
Replace Toner
Replace WT Box
Cause
The machine has a mechanical
problem.
One of the issues that can cause
this error is that condensation
may form inside the machine after
a room temperature change.
Registration failed.
It is time to replace the belt unit.
It is time to replace the drum
units.
The drum unit counter was not
reset when a new drum was
installed.
It is time to replace the drum unit
for the indicated colour.
It is time to replace the fuser unit. Call your Brother dealer to replace the fuser
It is time to replace the paper
feeding kit.
The toner cartridge is at the end
of its life.
It is time to replace the waste
toner box.
Troubleshooting and routine maintenance
Action
Do one of the following:
Disconnect the machine from the power
for several minutes, then reconnect it.
If the problem continues, call your
Brother dealer.
Turn the power switch off and fully open the
top cover. Leave the machine off and open
for 30 minutes to remove any condensation
from inside the machine, then close the top
cover and turn the machine on again. If this
does not clear the error, call your dealer or a
Brother Customer Service.
Press Mono Start or Colour Start and try
again.
Do one of the following:
Turn off the machine's power switch.
Wait a few seconds, then turn it on again.
Try Manual Registration, Menu, 3, 7.
(See Manual Registration on page 85.)
Put in a new belt unit. (See Replacing the
belt unit on page 98.)
If the problem continues, call your
Brother dealer.
Replace the belt unit. (See Replacing the
belt unit on page 98.)
Replace the drum units.
(See Replacing the drum units on page 95.)
Reset the drum unit counter.
(See Resetting the drum counter
on page 98.)
Replace the drum unit for the colour
indicated on the LCD.
(See Replacing the drum units on page 95.)
unit.
Call your Brother dealer to replace the PF
Kit.
Replace the toner cartridge for the colour
indicated on the LCD. (See Replacing a
Toner cartridge on page 88.)
Replace the waste toner box. (See
Replacing the waste toner box on page 102.)
C
67