Auto Registration; Manual Registration - Brother DCP-9010CN User Manual

e
Press Stop/Exit.
Note
• If an error message is displayed, press
Stop/Exit and try again. For more
information, see Error and maintenance
messages on page 64.
• If you print using Windows
you need to perform the calibration from
®
the Windows printer driver. See
Advanced tab in the Software User's
Guide on the CD-ROM.
• If you print using the Macintosh printer
driver, you need to perform the calibration
using the status monitor. See Status
Monitor in the Software User's Guide on
the CD-ROM. When the Status Monitor
is open, choose Control/Color
Calibration from the menu bar.

Auto Registration

Registration
If solid areas of colour or images have cyan,
magenta or yellow fringes, you can use the
auto-registration feature to correct the
problem.
a
Press Menu, 3, 6, 1.
b
To start, press 1.
To exit, press 2.
c
Press Stop/Exit.
Frequency
You can set the machine to carry out auto
registration regularly, and also how often it
occurs.
a
Press Menu, 3, 6, 2.
b
Press a or b to choose Low, Medium,
High or Off.
Press OK.
c
Press Stop/Exit.
®
printer driver,
C
C
C
Troubleshooting and routine maintenance

Manual Registration

If colour still appears incorrectly after auto-
registration, you will need to perform manual
registration.
a
Press Menu, 3, 7, 1.
b
Press Mono Start or Colour Start to
start printing the colour registration
chart.
c
When the machine has finished printing
the registration sheet, press 2
(Set Registration) to correct the
colour manually.
d
Starting at 1 (Magenta) on the chart,
check which coloured bar has the most
uniform print density and enter its
number into the machine using the a
and b keys.
Press OK.
Repeat for 2 (Cyan), 3 (Yellow), 4, 5, 6
to 9.
e
Press Stop/Exit.
C
C
85