Selecting The Cd Input Source; Repeating The Current Track - Grundig RRCD 2410 User Manual

CD MODE (RRCD 2410/2420 MP3)
The device is suitable for music CDs displaying the logo shown here (CD-DA) and for
CD-Rs and CD-RWs with audio data.
When burning CD-R and CD-RWs with audio files, various problems may arise
which could lead to interference in playback. This can be caused by faulty software or
hardware settings or by the CD being used. Should such problems arise, contact the customer
services of your CD burner or software manufacturer or look for relevant information, for
example on the Internet. When you are making audio CDs, observe all legal guidelines and
ensure that the copyright of third parties is not infringed.
Always keep the CD compartment closed to prevent dust from collecting on the laser optics.
Do not attach adhesive labels to CDs. Keep the surfaces of CDs clean. You can play standard
12 cm CDs as well as 8 cm CDs on your device. An adapter is not necessary.

Selecting the CD input source

1 Move the »CD TAPE/OFF
Press »OPEN/CLOSE« to open the CD compartment.
2
Insert a CD in the compartment with its label facing upwards.
3
Press »OPEN/CLOSE« to close the lid of the CD compartment.
4
– The device reads the content of the CD. The total number of tracks appears in the
display.
CD playback
Press »PLAY/PAUSE
1
– Playback begins with the first track.
– Display: the current track number.
– Playback stops at the end of the CD.
Press »PLAY/PAUSE
2
Press »PLAY/PAUSE
3
Press »STOP « to end playback.
4
7
Press »OPEN/CLOSE« to open the CD compartment and take out the CD.
5
6 Close the CD compartment.

Repeating the current track

1 Press »DOWN 8
– The track is repeated from the beginning.
RADIO« switch to the »CD« position.
II« to start playback.
II« to pause playback pause.
II« to resume playback.
« briefly during playback.
__________
33