Connecting Vc-201A / Vc-204; Connecting Standalone Pc - Planet VC-201A User Manual

to the telephone line system, on the other hand, need to install
a Slave (VC-201A / VC-204 CPE) converter on the individual
client side and connect to the Multi-port Master through the
telephone lines.
When deciding where to put the converter then you must
ensure:
It is accessible and cables can be connected easily.
l
Cabling is away from sources of electrical noise such as
l
radios, transmitters and power lines and fluorescent lighting
fixtures.
Water or moisture can not enter the Converter.
l
Air flow around the unit and through the vents in the side
l
of the case is not restricted (company recommend that you
provide a minimum of 25mm inch clearance)
To prolong the operational life of your units:
Do not place objects on top of any unit or stack
l

3.2 Connecting VC-201A / VC-204

3.2.1 Connecting Standalone PC

Refer to the following procedures to setup the VC-201A to a
standalone PC.
1. Set the VC-201A to be CO mode or CPE mode from the DIP
switch at the rear panel.
2. Power on the VC-201A by connecting its power source.
3. Power LED will illuminate.
4. Connect VDSL line from another VDSL device to VDSL port of
the VC-201A.
5. LNK LED will from blinking to illuminate.
21