Connecting Vc-201A / Vc-202A / Vc-204 - Planet VC-201A User Manual

3.2 Connecting VC-201A / VC-202A / VC-204

3.2.1 Connecting Standalone PC
Refer to the following procedures to setup the VC-201A to a
standalone PC.
1. Set the VC-201A to be CO or CPE mode from the DIP switch
at the rear panel.
2. Power on the VC-201A by connecting its power source.
3. Power LED will illuminate.
4. Connect VDSL line from another VDSL device to VDSL port of
the VC-201A.
5. LNK LED will blink to illuminate.
6. Connect telephone to the PHONE port.
7. Connect Ethernet port to PC Network Interface Card (NIC) via
regular Cat. 5, 5e or 6 cable.
Phone
RJ-11 Line Cord
RJ-11 Phone Jack
Figure 3-4: Connecting Standalone PC
Phone
VDSL
TP
RJ-11 Line Cord
VC-201A
RJ-45
Cat.5 Twisted Pair Cable
25