Modes And Functions; Time Mode; Pace Mode - Acumen TZ-MAX 100 Instruction Manual

Stp/Sto/Clr
• Press Mode/Nxt button to toggle
EL
• Press Set button to enter or exit
Set
Note: If no button is pressed for 60
Rcl/View
Mode/Nxt seconds, the watch will automatic-
ally exit the setting mode.
Str/Lap/TZ
(III) Modes and Functions

Time Mode

You can get the following information in this mode:
• Time, Date, Month and Weekday.
• Heart Rate with audible and visual Target
Zone Alarm if the Target Zone Alarm is on.
• " " icon indicates Time Alarm status.
• " " icon indicates Hourly Chime status
• View the watch ID.
Operation in this mode:
- Press and hold Rcl/View button to view the current exercise session.
- Press and hold Str/Lap/TZ button to view the Watch ID.
Note: You may change your Watch ID by using the Acuman Software.
Setting the Time
You can set 12/24 Hour Mode, Hour, Minute, Second, Year, Month and
Date.
- Press Set button to enter or exit the Time Setting.
- Press Mode/Nxt button to toggle between parameters.
- Press Stp/Sto/Clr or Rcl/View button to increase/decrease parameters.
(the Second will be reset to zero)
Note: weekday is auto-set based on the date and month entries.

Pace Mode

(This feature is not included in TZ Max 50)
The Pace feature is a programmable beeping sound which allows you
to set beeping rhythm for use as guidance to regulate your exercise, keep
your exercise pace in sync with that rhythm.
between modes.
Setting Modes.
• Total timers in a cycle, the current timer number, total cycle, current
on-going countdown timer.
• Each timer, every cycle and the final timer are respectively signaled
by a short beep, a short double beep, one long beep, and display
"OVERTIME"when finished.
• "Auto" icon indicates the interval timer status. If it is "ON", the interval
timers will be controlled by the stopwatch, or "OFF"when you want
to control it manually.
• Heart Rate with audible and visual Target Zone Alarm if the Target
Zone Alarm is on.
Operation in this mode:
- Press Str/Lap/TZ button to start the interval timer.
- Press Stp/Sto/Clr button to pause/stop the interval timer.
- Press & hold Stp/Sto/Clr button to clear timer when it is stopped.
Setting Interval Timers
You can set each interval timer, it's sequence in a cycle and total cycle
number.
- Press Set button to enter or exit the Interval Timer Setting.
- Press Mode/Nxt button to toggle between parameters.
- Press Stp/Sto/Clr or Rcl/View button to adjust parameters.
Alarm Mode
The unit includes 5 Alarms. These alarms can be programmed to operate
independently of each other, on specific days or every day.
You can get the following information in this mode:
• Alarm number (1~5)
• Alarm Time , Date or Weekday.
• " " icon indicates Alarm status(ON or OFF).
• " " icon indicates Hourly Chime status(ON or OFF).