Modes Of Operation; Basic Use Of Setting Modes - Acumen BASIX PLUS Mount Instruction Manual

Clear Workout Data
Press and hold the RESET button for 3 seconds
while in the Heart Rate/Stopwatch mode and
with the Stopwatch timer stopped. You will
hear a second beep and the stopwatch timer
display will reset to zeros. The previous data
will be saved in the memory for recall until
it is replaced with new data by starting a
new workout.
Setting Audible Alarm ON & OFF
The audible alarm for both the Daily Alarm
and the Target Zone Range can be turned
ON/OFF by pressing and holding the Alarm
button. To indicate this, the alarm indicator
" " on the display will switch ON or OFF.
To switch the Daily Alarm ON/OFF press and
hold the Alarm button while in the Time/Date
Mode. (When this alarm is beeping, it can be
silenced by pressing any button.)
To switch the Target Zone Alarm ON/OFF
press and hold the Alarm button while in the
Heart Rate/Stopwatch Mode.
Battery Replacement
We recommend that you should take it to a
local jewelry store or an authorized Acumen
service center in order to guarantee that it will
maintain its water resistance. Improper battery
replacement or service will void the warranty.
Repairs should only be performed by an
Acumen service center. Refer to the service card
for further details.
14

Modes of Operation

To toggle through different modes, press the
MODE/SET button.
Press & Hold
Set button
Time/Date
Press Mode button
Press & Hold
Heart Rate
Set button
/Stopwatch
Press Mode button
Press
Memory
Mode button
Recall
Press Mode button

Basic Use of Setting Modes

The clock setting is accessed from the Time/Date
mode, and the Target zone setting is accessed
from the Heart Rate/Stopwatch mode.
• Press and hold the MODE/SET button to enter
the setting modes.
• Adjust blinking digits with the RESET or ALARM
button.
• Press the RESET button to increase or ALARM
button to decrease the digits. Press and hold to
change the digits faster.
• Proceed to the next setting option with the
MODE/SET button.
• To exit setting mode when finished, just press
and hold the MODE/SET button.
Note: If no button is pressed for 60 seconds,
the watch will automatically exit the setting
mode.
Set Time, Date & Daily Alarm
Set Personal Data
Recall Memory Data
.
7