Polycom HDX Room Systems User Manual page 16

User's Guide for Polycom HDX Room Systems
12
If far-site camera control is allowed, you can create up to 16 presets (0-15) for
the far-site camera. These presets are saved only for the duration of the call.
You may also be able to use presets that were created at the far site to control
the far-site camera.
To move the camera to a stored preset:
If a call is connected, press
1
choose a near-site or far-site camera.
Press a number on the remote control.
2
To view your near-site presets:
>> Press Preset on the remote control.
Icons for presets 0-9 are shown on the screen. The colored icons indicate
stored camera positions, and the gray icons indicate unassigned presets.
To store a preset:
If you are in a call, press
1
choose a near-site or far-site camera or other video source.
With the camera in the desired position, press and hold a number to store
2
the preset position. To store a double-digit preset, press the first digit
quickly and hold the second number down. Any existing preset stored at
the number you enter is replaced.
The system uses preset 0 as the default camera position.
To delete all presets:
If you are in a call, press
1
video source.
Press Preset on the remote control.
2
Press and hold
3
You cannot delete just one preset. Instead, overwrite an existing preset with the
new camera position.
Near or
Near or
Near, and then choose a near-site
Delete to delete all presets.
Far, and then
Far, and then
Polycom, Inc.