Printing From Windows Nt 3.5 (Tcp/Ip) - Axis 16852 User Manual

Section 4: Printing from Windows NT 3.5 (TCP/IP)
32
Section 4
Before you begin
Installation Steps

Printing from Windows NT 3.5 (TCP/IP)

This section describes how to install the AXIS OfficeBasic for
TCP/IP printing on Windows NT3.5x clients.
Make sure that the TCP/IP protocol is enabled on your
Windows client.
To complete the installation you need to perform the following
steps:
• Physically connect the AXIS OfficeBasic to your network and
assign an ip address to the print server. See Hardware
Installation and IP address assignment, on page 12.
• Install the AXIS Print Monitor software on your client. Please
refer to page 33.
• Integrating the AXIS OfficeBasic in your network and
installing the TCP/IP printer ports on your client. Please refer to
page 35.
User's Manual