Power The Device - Rand McNally intelliroute TND 500 User Manual

Rand McNally IntelliRoute ® TND TM 500 User's Guide
Note:
Obey all local regulations governing the placement of the mount.
Note:
Do not place the mount in an airbag deployment area.
1 Clean and dry the mounting area.
2 Remove the suction cup protective film.
Adjust the angle and secure the cradle to the mount using the thumbscrew.
3
Pull the suction cup lever up to release suction.
4
5 Place and hold the mount suction cup against the mounting surface.
6 Press the suction cup lever down until it snaps into place.
Angle the bottom of the device into the cradle and align the two slots on
7
the bottom of the device into the two projections on the cradle.
8 Press the top of the device towards the cradle until you hear two clicks
indicating the device is fully secured.
9 Plug the power cord into the device and the vehicle's 12 volt power source.
10 Adjust the navigation device so that it can be easily seen and does not block
the driver's line of sight.

Power the Device

Note:
To maximize battery life, plug in the IntelliRoute® TND™ 500 for the first
two (2) hours of use. See "First Time Use" on page12.
13