Accessories; Before Using; Cautions On Installation; Cautions On Handling - Denon AVC-A11XV Operating Instructions Manual

Getting Started
Thank you for choosing the DENON AVC-A11XV Digital Surround A / V amplifier. This remarkable component has
been engineered to provide superb surround sound listening with home theater sources such as DVD, as well as
providing outstanding high fidelity reproduction of your favorite music sources.
As this product is provided with an immense array of features, we recommend that before you begin hookup and
operation that you review the contents of this manual before proceeding.

Accessories

• Check that the following parts are included in addition to the main unit:
q
Operating instructions.......................................1
w Service station list.............................................1
e Power supply cord ............................................1
r Remote control unit (RC-995) ...........................1
e r

Before using

Pay attention to the following before using this
unit:
• Moving the set
To prevent short circuits or damaged wires in the
connection cords, always unplug the power supply
cord and disconnect the connection cords between
all other audio components when moving the set.
• Before turning the Power switch on
Check once again that all connections are proper
and that there are not problems with the connection
cords. Always set the power switch to the standby
position before connecting and disconnecting
connection cords.
t R03/AAA alkaline batteries ...............................4
y Omnidirectional microphone.............................1
u List of preset codes ..........................................1
t y
• Store these instructions in a safe place.
After reading, store these instructions along with
the warranty in a safe place.
• Note that the illustrations in these instructions
may differ from the actual set for explanation
purposes.

Cautions on installation

Noise or disturbance of the picture may be generated
if this unit or any other electronic equipment using
microprocessors is used near a tuner or TV.
If this happens, take the following steps:
• Install this unit as far as possible from the tuner or
TV.
• Set the antenna wires from the tuner or TV away
from this unit's power supply cord and input/output
connection cords.
• Noise or disturbance tends to occur particularly
when using indoor antennas or 300
wires. We recommend using outdoor antennas
and 75 /ohms coaxial cables.
Note:
For heat dispersal, do not install this equipment in
a confined space such as a book case or similar
unit.

Cautions on handling

• Switching the input function when input
terminals are not connected.
A clicking noise may be produced if the input
function is switched when nothing is connected to
the input terminals. If this happens, either turn
down the MASTER VOLUME control knob or
connect components to the input terminals.
• Muting of PRE OUT terminals and SPEAKER
terminals.
The PRE OUT terminals and SPEAKER terminals
include a muting circuit. Because of this, the output
signals are greatly reduced for several seconds after
the power switch is turned on or input function,
surround mode or any other-set-up is changed. If
the volume is turned up during this time, the output
will be very high after the muting circuit stops
functioning. Always wait until the muting circuit
turns off before adjusting the volume.

Preparing the remote control unit

The included remote control unit (RC-995) can be used to operate not only the AVC-A11XV but other remote
control compatible DENON components as well. In addition, the memory contains the control signals for other
remote control units, so it can be used to operate non-DENON remote control compatible products.
2
ENGLISH
Note
/ohms feeder
• Whenever the power switch is in the STANDBY
state, the apparatus is still connected on AC line
voltage.
Please be sure to turn off the power switch or
unplug the cord when you leave home for, say, a
vacation.
ENGLISH
Getting Started
Wall