Advertisement
PAPER BAG REMOVAL
AND REPLACEMENT
NOTE: Disconnect cleaner from electrical outlet for maintenance.
Replace the paper bag when approximately one-half full.
Set the tank on end with the exhaust vent (rear bell) on the floor.
Grasp the bell clamps in each hand. Holding your hands toward the
rear of the clamp, pull outward.
Grasp the. front end bell (the hose may still be connected), gently pull
outward. Take care not to spill any dirt. Pull off paper bag and discard.
The cloth bag in the tank does not always have to be removed for
cleaning. If cleaning is required, remove the bag and shake dirt into a
suitable container.
Replace with a new paper bag. Place the hole in the paper bag over
the metal fitting inside the front end bell.
Place the front end bell back onto the tank by sliding the paper bag
into the tank. The chrome end plate must slide over the edges of the
tank. Hold in place and fasten the bell clamps to both sides. Clamps
will "snap" into place when fully seated.
Continue normal operation of your vacuum cleaner.
Advertisement
