Store Performance - Generalmusic WK1000 Owner's Manual

owners manual
Parameter
VOLUME
MD=MONO
REVSEND
CHOSEND
TRANSP
DETUNE
PAN
VOLPED
DAMPER: (ON/OFF)
PITCH/M M
PITCHRG
EDITSND
Use the TEMPO/DATA buttons to modify each values.
You can exit any edit page at any time without losing your temporary modifi cations. Save your modifi cations
if you decide to change to a new Performance. Selecting a new Performance, or selecting the current one
again, will imply losing your data unless you save them.
The STORE PERFORMANCE function key allows you to to save the panel confi guration setting to a Per-
formance. Use the STORE PERFORMANCE function whenever you have accomplished one of the actions
described in the previous paragraph. In this way you will freeze the desired panel setting and you will be
able to recall it at all times.
Press ENTER or ESCAPE to save or exit from the
Store Performance operations.
Use the PERFORMANCE RECALL/STORE PERFORM-
ANCE key to enter Performance mode: the arrowhead
moves automatically to the PERF menu function.
The original Performances set by the factory cannot be cancelled, but can be restored at all times by
using the RESTORE function.
IMPORTANT: Using this function the factory-set Performances will be restored to the original mem-
ory locations, clearing the location contents. Make sure that your programmed performances will
be saved to a Floppy Disk before resetting with RESTORE.
To save Performances to disk, refer to the Disk chapter. If you modify the fi rst of the 63 available
Performances, this will appear whenever wk1000 is turned on. You may choose not to store your
programmed Performances to disk but keep them in the machine RAM memory taking advantage of
the battery back-up. Keep in mind that in case the battery runs down all your data will be irretrievably
lost.
Page22
PERFORMANCE PARAMETERS
Value range
00 - 127
ON/OFF
00 -15
00 -15
24/+24 (semitones)
-63/+63 (1/64th of a
semitone)
00/31 right 00/-31 left
ON/OFF
ON/OFF
ON/OFF
00/12
ON/OFF

STORE PERFORMANCE

Note
Displays the track Volume
UPPER1 section only,
Set the monophonic mode in the UPPER 1 sec-
tion
Indicates the Reverb level in the track
Indicates the Chorus/Delay/modulation effects level in the
track
Indicates the transpose setting
Indicate the fi ne tuning of the tracks
Moves the sound of the track to the left or to the right
By setting this value to the minimum with the TEMPO/DATA but-
tons, the PAN mute message appears in the display; the sound is
no longer heard but the effects are still active in the track. In this
case, you will only hear the effect processed sound.
Enables or disables the Volume Pedal control on the track (the
Volume Pedal is optional and must be connected to the rear
panel jack socket).
Enables or disables the Damper Pedal control. The Damper
Pedal is optional and must be connected to therear panel jack
socket).
Enables or disables the action of the Pitch/Modulation control
in the track
Indicates the Bender range: if the value is 00, the Pitch Bender
wheel will have no effect on the track. A value higher than 00
indicates the wheel action in semitones (e.g.: 12=1 octave)
This function allows to play a WK3 song with edited sounds as
the original instrument. (ON by default)
wk1000
sounds and performances