Checking And Adding Oil; Replacing Transmission Oil - Honda CRF250X Owner's Manual & Competition Handbook

JASO T 903 standard
The JASO T 903 standard is an index to choose
engine oils for 4-stroke motorcycle engines.
There are two classes: MA and MB.
Oil conforming to the standard has the following
classification on the oil container.
(1) code number of the sales company of the oil
(2) oil classification
Checking & Adding Oil
(1)
(2) (2)
(1)
(1) transmission oil filler cap
(2) oil check bolt
1. Run the engine for 3 minutes, then shut it off.
2. Wait 3 minutes after shutting off the engine to
allow the oil to properly distribute itself in the
clutch and transmission.
3. Support the CRF in an upright position on a
level surface.
4. Remove the transmission oil filler cap (1) and
oil check bolt (2) from the right crankcase
cover. A small amount of oil should flow out
of the oil check bolt hole. Allow any excess
oil to flow out of the oil check bolt hole.
If no oil flows out of the oil check bolt hole,
add oil slowly through the transmission oil
filler hole until oil start to flow out of the oil
check bolt hole.
Install the oil check bolt and transmission oil
filler cap. Repeat step 1–4.
5. After inspection the oil level or adding oil,
tighten the oil check bolt to the specified
torque:.
Oil Check Bolt: 7 lbf·ft (10 N·m, 1.0 kgf·m)
6. Install the transmission oil filler cap securely.
Transmission Oil

Replacing Transmission Oil

1. Run the engine for 3 minutes, then shut it off.
2. Support the CRF in an upright position on a
level surface.
3. Remove the transmission oil filler cap (1)
from the right crankcase cover.
4. Place an oil drain pan under the engine to
catch the oil. Then remove the transmission
oil drain bolt (2) and sealing washer (3).
5. After the oil has drained, install the
transmission oil drain bolt with a new sealing
(2)
washer to the specified torque:
16 lbf·ft (22 N·m, 2.2 kgf·m)
6. Fill the crankcase with recommended oil.
Capacity: 0.71 US qt (0.67R) at oil change
7. Check the transmission oil level by following
the steps in Checking & Adding Oil (this
page).
(1)
(1) transmission oil filler cap
(2) transmission oil drain bolt
(3) sealing washer
(3)
(2)
47
Servicing Your Honda