Honda CRF250X Owner's Manual & Competition Handbook page 51

7. Remove the left engine guard bolt (4) and left
engine guard (5).
(5)
(4)
(4) left engine guard bolt
(5) left engine guard
8. Remove the oil filter cover bolts (6) and oil
filter cover (7).
9. Remove the oil filter (8) from the cover.
10. Check that the oil filter cover O-ring (9) is in
good condition.
(10)
(12)
(9)
(6) oil filter cover bolts
(7) oil filter cover
(8) oil filter
(9) oil filter cover O-ring
(10) spring
(11) rubber seal
(12) "OUT-SIDE" mark
11.Apply grease to the seat face of spring (10).
12.Position the spring against the engine
crankcase and install a new oil filter with the
rubber seal (11) facing out, away from the
engine. You should see the "OUT-SIDE" mark
(12) on the filter body, near the seal.
Use a new genuine Honda oil filter or a filter
of equal quality specified for your model.
NOTICE
If the oil filter is not installed properly, it will
cause serious engine damage.
13.Install the oil filter cover O-ring and oil filter
cover being careful not to damage the O-ring,
then tighten the oil filter cover bolts to the
specified forque:
9 lbf·ft (12 N·m, 1.2 kgf·m)
14.Install the left engine guard and left engine
guard bolt.
15.Fill the crankcase with the recommended oil.
Capacity: 0.73 US qt (0.69R)
(8)
16.Install the engine oil filler cap/dipstick.
(11)
17.Check the engine oil level by following the
steps in Checking & Adding Oil (page 44).
(7)
(6)
at oil and filter change
0.70 US qt (0.66R)
at oil change
Engine Oil
45
Servicing Your Honda