Placing A Standard Private Conversation Call - E.F. Johnson Company 5300 SERIES Operating Manual

the ringing but not the call. When the call is
answered, the voice of the called party is heard.
•
If the called mobile does not answer within 20
seconds, a continuous tone sounds and "NO ANS"
is displayed.
•
If the called mobile is not on the air, a continuous
tone sounds instead of the ringing tone and "NO
ACK" is displayed.
•
If the busy tone sounds and "BUSY" is displayed,
the called mobile has answered the call but the
system is busy. When the system is no longer busy,
the call back tone sounds.
•
If your radio or the called radio is inhibited or not
programmed to make this type of call or for the
requested secure mode, "RSPNS ONLY" is
displayed and an alert tone sounds.
•
If your radio does not have the proper encryption
key, "KEYFAIL" is displayed and the call must be
made in the clear mode by pressing the C/S
(Clear/Secure) option switch (if encryption is
selectable on the channel). Otherwise, the correct
key must be loaded.
7. When the call is finished or is not answered, end it
by pressing the CALL option switch and placing the
microphone back on-hook.
6.5.3 PLACING A STANDARD PRIVATE
CONVERSATION CALL
Recalling From A List
1. Momentarily press the CALL (Private Call) option
switch. The tag (alias) of the last called mobile is
displayed.
2. To select another mobile, rotate the Select switch
until the tag for the desired mobile is displayed.
3. Press the PTT switch to initiate the call.
(Proceed to the bulleted list which follows Item 6 in
the next section for events that may occur next.)
SMARTNET/SMARTZONE/P25 TRUNKED FEATURES
Direct Entry Using Front Controls or HHC Keypad
4. Press and hold the Private Call option key until a
tone sounds (approximately 1 second). The last ID
called is displayed.
5. If using the front panel controls, enter the ID of the
radio you are calling (five digits must be entered) by
rotating and pressing the Select switch. With the
HHC, enter the number using the DTMF keypad. To
cancel the call, press the Private Call Option key
again.
6. Press the PTT switch to initiate the call. If the
entered number is valid, the display indicates the
alias of the ID if it matches an ID in the call list.
Otherwise, the ID you entered continues to be
displayed.
Events that may then occur are as follows:
•
The called party answers the call.
•
The called party does not answer. Press the CALL
option switch to end the call.
•
If the selected mobile ID is not valid, "INVALID
ID" is displayed and an alert tone sounds.
•
If the radio system is busy, four low tones sound
and "BUSY" is displayed. When the system is no
longer busy, the call back tone (four beeps) is
heard and the channel is automatically acquired.
Press the PTT switch to continue the call.
•
If the call is in the secure mode and your radio
does not have the proper encryption key,
"KEYFAIL" is displayed and the call must be
made in the clear mode by pressing the C/S
(Clear/Secure) option switch (if encryption is
selectable on the channel). Otherwise, the correct
key must be loaded.
7. When the call is finished or if it is not answered, end
it by pressing the CALL option switch and placing
the microphone on-hook.
42