About Cd Writer Not Readable; About High Failure Rate; About Firmware Update; About Function 12 And Cancellation - Acard ARS-2030L User Manual

6.5 About CD Writer Not Readable

After copying if the CD writer is not readable, please use Compare to examine, or
get another CD-ROM to test.

6.6 About High Failure Rate

If the failure rate of copying is high, please do the following things to improve.
l
Lower the speed of CD writer.
l
Inspect if the blank disk's quality is bad.
l
Update the firmware.
l
Inspect the CD writer's maximum writing speed. If the speed is over 24X,
copy the data to a hard disk first, and then transmit to CD.

6.7 About Firmware Update

If you cannot update the firmware, please inspect the BIOS program. Perhaps you
have downloaded a wrong program, or let a zipped file be written into CD. The
zipped file should be unzipped first.
Failure in firmware update may cause the copy smart plus to fail in booting. Under
the circumstances, please return the control board to ACARD for repair.

6.8 About Function 12 and Cancellation

If you want to execute function 12 Advanced Setup, you can press ESC for 2 seconds.
And during operation if you want to cancel a function like Copy, Test, Verify and so
on, you can press ESC for 2 seconds, too.
ARS-2030L/2032 Manual
65