No sound.
• Securely connect all audio cables.
• Repair or replace any damaged audio or speaker cables.
• Press MUTE button on remote control if mute icon is displayed on the TV screen.
• The system is in Pause, Slow Motion, Forward/Reverse Scan. Press PLAY on the remote control to return to
• Check speaker levels.
Severe hum or noise.
• Make sure speakers and components are correctly and securely connected.
• Make sure connecting cables are away from a transformer or motor, and at least 10 feet away from a TV or
• Move your TV away from your audio components.
• The plugs and jacks are dirty. Wipe them with a cloth slightly moistened with alcohol.
• Clean the disc.
No stereo sound during VCD/
• Refer to VCD/CD audio setup on page 16 and page 30.
CD playback.
• Check speaker connections and settings.
No surround effect during play-
• Refer to DVD audio setup on page 15 and page 27.
back of Dolby Digital
• Check speaker connections and settings.
soundtrack.
• Depending on the DVD, the output signal may not use all 5.1 channels, but rather output monaural or stereo
Cannot tune in radio stations.
• Make sure antennas are securely connected. Adjust the antennas and connect an external antenna if necessary.
• The signal strength of the stations is too weak (when tuning in with automatic tuning). Use manual tuning.
• No stations have been preset or the preset stations have been cleared. Preset the stations.
Remote does not function.
• Remove any obstacles between the remote and the system.
• Move closer to the system when operating the remote.
• Point the remote directly at the sensor on front panel of the system.
• Replace the batteries.
Disc does not play.
• Make sure there is a disc in the tray.
• Turn the disc over. Make sure the playback side is facing down on the disc tray.
• The disc is skewed or warped.
• The region code on the DVD does not match the system.
• Moisture has condensed inside the system. Remove the disc and leave the system turned on for about half an
Disc does not start playing
• Program Play or Repeat Play is selected. Press CLEAR to cancel these functions before playing a disc.
from the beginning.
• Resume Play is active. Press STOP twice and then restart DVD playback.
34
normal playback mode.
fluorescent light.
sound, even if the soundtrack is recorded in Dolby Digital format.
hour.