Table of Contents
Advertisement
Chapter 2
:: Connecting the System
Follow these seven steps to connect the DVD system. It is recommended that you turn off power on all components (or unplug AC
power) while you are connecting the system.
Step 1 - Connect TV
Composite Video
Connect the supplied video cable from the Video Out jack on the back panel of the DVD system to your
television's Video In jack.
S-Video
For better video quality, you can connect the system to your TV with an S-Video cable (not included). Connect the
S-Video cable from the S-Video Out jack on the back panel of the system to your television's S-Video In jack.
Step 2 - Place Speakers
For best results, arrange the six speakers as shown in your
listening area:
Front Speakers (L, R)
they are aligned at ear level and at a horizontal angle
of 45 degrees to the primary listening area.
Center Speaker (C)
The center speaker should
be positioned with its top surface flush with the front
speakers. However, you may place the speaker either
on top of or next to your TV set.
Rear Speakers (LS, RS)
speakers further back, parallel to the walls, at 2 to 3
feet above the ear level of the primary listening area.
If the space behind the listening area is limited (i.e.,
close to the wall), place the rear speakers facing each
other on either side.
Subwoofer (SUB)
Place the subwoofer at any
convenient location within the vicinity of the listening
area.
Set the front speakers so
Set the surround
Connections
7
Advertisement
Table of Contents
