Adjustment Of The Display (Direct; Returning The Screen Adjustment To The Factory Default Settings (Normal - NEC PlasmaSync 42PD2 User Manual

Adjustment of the Display (Direct)

Press the buttons of the remote control to make direct ad-
justments and settings. A press of the desired button will
show the adjustment display. The adjustment condition is
stored in memory even after the power is switched off.
Preparation: Select the input screen (VIDEO, RGB1,
RGB2, RGB3) that is to be adjusted, after the input signal
is connected.
Adjustment of the Screen
The adjustment of screen size is made easier when a geo-
metric shape such as a square is displayed.
Press the button to show the adjustment display. The dis-
play will go off about 3 seconds after your finger is re-
leased from the button.
Adjustment of the screen display position
POSITION / CONTROL
Move up
Move left
Adjustment display of the up/down position
V-POSITION
MOVE DOWN
Adjustment display of the left/right position
H-POSITION
MOVE LEFT
NOTE: See page 28 on how to adjust the H/V-Positions.
Move right
Move down
MOVE UP
MOVE RIGHT
E-21
Returning the Screen Adjustment
to the Factor y Default Settings
(NORMAL)
The display position (POSITION) will return to the fac-
tory default setting. At this time the following settings of
the menu control will also simultaneously return to the fac-
tory default settings: AUTO PICTURE, PICTURE AD-
JUST, FINE PICTURE, H/V-POSITION 1, H/V-POSI-
TION 2, H-WIDTH (Multiple Screens only), V-HEIGHT
(Multiple Screens only) and OSM location.
1. Press the RASTER NORMAL button
The verification sub menu is displayed.
RASTER
NORMAL
WARNING
ABOUT TO RESET
RASTER
PRESS:
'PROCEED' TO RESET
'EXIT' TO CANCEL
2. A press of the PROCEED button will reset the
adjustment.
To cancel the reset, press the EXIT button.
PROCEED
* Use the RASTER NORMAL button. A press of the
VISUAL NORMAL button will not return the screen
adjustment to the factory default setting.
* A press of the NORMAL button during the on-screen
display will return only the display item to the factory
default setting.
H-POSITION 1,2 and V-POSITION 1,2 are not avail-
*
able at the time of RGB input when AUTO PICTURE is
turned on.
To adjust H-POSITION 1,2 and V-POSITION 1,2 at the
time of RGB input, turn off AUTO PICTURE.