Honda CH250 ELITE250 Owner's Manual page 61

Clean the oil filter screen (2).
3.
Check that the oil filter screen, sealing
4.
rubber and drain plug O-ring are in
good condition.
Install the oil filter screen, spring and
5.
drain plug.
Torque: 18-22 N-m
(1.8-2.2 kg-m, 13-16 ft-lb)
Fill the crankcase with approximately
6.
0.8 !? (0.84 US qt.) of recommended
oil (page 54).
Start the engine and let it idle a few
7.
minutes.
* The rear wheel will spin if not restrain-
ed by the brake or contact with the
ground. Accidental contact with a
spinning rear wheel could cause per-
sonal injury.
56
8. Stop the engine and check that the oil
level is at the upper mark on the dip-
stick with the scooter on its center
stand.
Check that there are no oil leaks.