Caller Identification; Calls On Priority And Block Id Codes - E.F. Johnson Company MULTI-NET 98xx SERIES Operating Manual

Table of Contents

MULTI-NET FEATURES

message and exit this mode, press the FCN option switch again. This also

occurs automatically 2 seconds after a change is made or 8 seconds after

no changes are made.

Up to eight status conditions such as "AT SITE", "LEAVING", and

"LOADING" may be preprogrammed by your system operator. The

selected status condition along with the unique ID of your transceiver is

then displayed on the dispatcher's console whenever the transmitter is

keyed.

Caller Identification

The caller identification feature displays the four-digit unique ID of

the calling mobile. It is displayed on the bottom line as "UI XXXX"

alternately with the group alpha tag.

This feature can be turned on and off by the CALL ID menu param-

eter (see page 33). If this menu parameter is not available, the caller ID

feature is fixed in the on or off mode by programming. This feature is

also programmed on individual groups by your system operator. If it is

disabled on a group, the unique ID code is not displayed even if this

feature is enabled.

Two fixed priority and a block of receive ID codes can be

programmed. These codes are in addition to the receive and transmit ID

code selected by the group select function. Calls on the fixed priority and

block ID codes are received regardless of which group is selected or

group scanning. All that is required is that the system programmed with

those codes be selected or scanned.

Calls on the fixed priority ID codes have a higher priority than calls

being received on other ID codes. If a call with a higher priority is

detected while receiving a call, the current call is immediately dropped

and the higher priority call received. Telephone calls are not interrupted

by priority calls.

Table of Contents

Multi-net 98 series