Table of Contents
Advertisement
other selectable systems. While searching is occurring, "ROAMING" is
indicated on the lower line of the display as shown below. When a new
site is located, this message is no longer displayed, and the system and
group of the new site is displayed.
The new system is the first higher system with a different site that
could be accessed (wrap-around occurs after the highest system is
accessed). The new group is either the same group that was displayed
before roaming occurred or the last selected group of that system
(programming determines which is selected).
Transmitting Status Messages
Preprogrammed status messages can be transmitted whenever the
transmitter is keyed with a Multi-Net system selected. If this feature is
available, the STATUS menu parameter (see page 33) is programmed to
allow the desired message to be selected.
Selecting the STATUS menu parameter enables the status message
select mode. This mode is indicated by "STATUS" on the top line of the
display and the bottom line indicates the currently selected status
message (see following illustration).
To change the current message, press the Select switch. When "NO
STAT" is selected, no message is transmitted. To select the current
MULTI-NET FEATURES
Status Select Mode
Selected Status
Message
45
Advertisement
Table of Contents
