Pontiac None Aztek Owner's Manual page 396

3. Remove the J-hook and the wing nut from the back
of the jack access door. Assemble the wing nut and
the J-hook.
4. Install the wing nut and the J-hook to the D-ring
through the center hole of the tire.
5. Tighten the wing nut to secure the tire to the floor.
Push and pull on the tire to make sure the tire is
secure and does not move.
6. Put back all tools as they were stored in the jack
storage compartment. Attach the wrench back to
the jack. Put the jack base on the bracket tab
and sit the jack properly between the two "ears" of
the bracket. Use the bolt to tighten the jack.
7. Put the compartment cover back on, slip the tabs on
the bottom of the cover into the bottom of the cover
opening. Push the cover in place and push down the
tab on the top of the cover so that it rests in the
groove. This secures the cover in place.
5-100
Storing the Flat Tire with the Sliding Rear
Convenience Tray
A. D-ring
B. Sliding Rear
Convenience Tray
C. Wing Nut
D. J-hook
E. Full-size Tire
F. Storage
Compartment
Cap Hole