Table of Contents
Advertisement
SIDE BURNER ASSEMBLY INSTRUCTIONS
Side burner valve assembly:
Step 1: Insert valve assembly through top of side
panel
Step 3: Insert valve stem assembly into burner
venturi
Valve Stem
Valve
Step 5: Replace "U" brackets with 4(four)
Screws( DO NOT TIGHTEN)
#25
Step 7; Tight all 4(four) screws on the "U"
brackets on the burner, then connect
the ignition wire on to valve.
(Ignition wire)
Valve
(Side panel, right #23)
#30
Step 2: Remove 4(four) screws & washers
from the "U" brackets on the side
burner
Step 4: Insert valve stem assembly through knob
hole to the control panel
(Control Panel #25)
Step 6: Align & tighten knob bezel & valve
stem with 2(two) screws & washers
as shown below.
(knob bezel in bag)
Step 8: Place knob on valve stem, then screw
the knob by using the wrench tool.
9
(#
)
30
(Wrench tool enclosed in bag )
Hide quick links:
Advertisement
Table of Contents
