Brinkmann Elite Owner's Manual page 12

MATCH LIGHTING THE SIDE BURNER:
1. Open the lid to the side burner before lighting.
2. Turn the burner control knob to "OFF".
3. Strike and carefully place a match approximately 1/2" (1 to 2 cm) from the burner.
4. Turn the side burner control knob to the "HIGH" position. The burner should light within 5 seconds.
5. If the burner does not light, turn the control knob to "OFF" and wait 5 minutes for gas to dissipate and repeat
lighting procedure.
6. If the burner does not light within the first few attempts of match lighting, there is a problem with the gas supply.
Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the problem is found and
corrected. See "Trouble Shooting" section of this manual.
Note:
LIGHTING THE SEAR BURNER:
1. Open lid before lighting sear burner.
MATCH LIGHTING THE SEAR BURNER:
1. Open the lid to the sear burner before lighting.
2. Make sure control knob is in the "OFF" positi on.
3. Strike and carefully place a match approximately 1/2" (1 to 2 cm) from the sear burner.
4.
5. If the burner does not light, turn the control knob to "OFF" and wait 5 minutes for gas to dissipate and repeat
lighting procedure.
6. If the burner does not light within the first few attempts of match lighting, there is a problem with the gas supply.
Turn off the gas at the burner and cylinder. DO NOT attempt to operate the sear burner until the problem is found
and corrected. See "Trouble Shooting" section of this manual.
Note: Observe flame height on main and side burners when
lit: Flame should be a Blue/Yellow color between
1"–2" when burner is on "HIGH."
TURNING OFF THE GRILL:
1. Turn off the cylinder valve.
2. Turn all burner control knobs to the "OFF" position.
Note: Turn off LP cylinder first to prevent gas
from being left in the system under pressure.
CAUTION:
• The cylinder valve should always be in the off,
or closed, position when the grill is not in use.
11
To turn off the cylinder valve,
turn knob clockwise until it stops.