Safety Rules For Laser Lights; General Safety Rules - GMC LS750P JM Instruction Manual

Safety rules for laser lights

The laser light/laser radiation used in the GMC REDEYE
system is Class 2 with maximum ≤1mW and 400 – 700nm
wavelength. These lasers do not normally present an optical
hazard, although staring at the beam may cause flash
blindness.
WARNING. Do not stare directly at the laser beam.
A hazard may exist if you deliberately stare into the beam,
please observe all safety rules as follows;
• The laser shall be used and maintained in accordance
with the manufacturer's instructions.
• Never aim the beam at any person or an object other
than the work piece.
Do not stare into beam. Class 2 laser product
Wave Length:400-700nm, Output Power: 1mW
• The laser beam shall not be deliberately aimed at
personnel and shall be prevented from being directed
towards the eye of a person for longer than 0.25s.
• Always ensure the laser beam is aimed at a sturdy work
piece without reflective surfaces. i.e. wood or rough
coated surfaces are acceptable. Bright shiny reflective
sheet steel or the like is not suitable for laser use as
the reflective surface could direct the beam back at the
operator.
• Do not change the laser light assembly with a different
type. Repairs must only be carried out by the laser
manufacturer or an authorised agent.
CAUTION. Use of controls or adjustments or performance
of procedures other than those specified herein may result
in hazardous radiation exposure.
Please refer to the relevant Australian standards, AS 2397
and AS/NZS 2211 for more information on Lasers.
LASER LIGHT. LASER RADIATION
AS/NZS2211.1:2004

General safety rules

WARNING. Read all instructions. Failure to follow all
®
instructions listed below may result in electric shock,
fire and/or serious injury. The term "power tool" in all of
the warnings listed below refers to your mains operated
(corded) power tool or battery operated (cordless)
power tool.
Save these instructions
1. Work area
a. Keep work area clean and well lit.
areas invite accidents.
b. Do not operate power tools in explosive
atmospheres,
liquids, gases or dust. Power tools create sparks which
may ignite the dust or fumes.
c. Keep children and bystanders away while
operating a power tool.
lose control.
2. Electrical safety
a. Power tool plugs must match the outlet. Never modify
the plug in any way.
earthed (grounded) power tools. Unmodified plugs and
matching outlets will reduce risk of electric shock.
b. Avoid body contact with earthed or grounded
surfaces such as pipes, radiators, ranges and
refrigerators.
if your body is earthed or grounded.
c. Do not expose power tools to rain or wet conditions.
Water entering a power tool will increase the risk of
electric shock.
d. Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the power tool.
Keep cord away from heat, oil, sharp edges or moving
parts. Damaged or entangled cords increase the risk of
electric shock.
4
Cluttered and dark
such as in the presence of flammable
Distractions can cause you to
Do not use any adapter plugs with
There is an increased risk of electric shock