GMC LS920SR Instruction Manual
GMC LS920SR Instruction Manual

GMC LS920SR Instruction Manual

920w pendulum jigsaw with lightsabre

Advertisement

Quick Links

I N S T R U C T I O N M A N UA L
920W
Pendulum Jigsaw
with LightSabre
• London • Melbourne • Perth • Taipei • Verona
• Hong Kong • New York • Auckland • Paris
LS920SR
020919 LS920SR ED7

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LS920SR and is the answer not in the manual?

Questions and answers

Summary of Contents for GMC LS920SR

  • Page 1 I N S T R U C T I O N M A N UA L 920W Pendulum Jigsaw with LightSabre LS920SR • London • Melbourne • Perth • Taipei • Verona • Hong Kong • New York • Auckland • Paris 020919 LS920SR ED7...
  • Page 2: Table Of Contents

    Cutting metal It also does not cover any bonus accessories unless the Fitting the straight guide tool is a GMC Platinum Professional model. Changing a blade Please ensure that you store your receipt in a safe place. Using the LightSabre system Conditions apply to the above warranty.
  • Page 3: Introduction

    Wear eye protection. Wear breathing protection. Introduction Double insulated Your new GMC power tool will more than satisfy your for additional protection. expectations. It has been manufactured under stringent GMC Quality Standards to meet superior performance Conforms to relevant criteria.
  • Page 4: General Safety Instructions

    beam, please observe all safety rules as follows; imperative that you observe the accident prevention regulations in force in your area. The same applies for • The laser shall be used and maintained in accordance general rules of occupational health and safety. with the manufacturer’s instructions.
  • Page 5: Additional Safety Rules For Jigsaws

    disconnect the tool from the power point. Keep the conditions that may affect the operation of the tool. cord away from heat, oil and sharp edges. A part that is damaged should be properly repaired or replaced by an authorised service facility, unless 10.
  • Page 6: Unpacking

    • Before cutting, check that there is sufficient clearance • Always hold the saw on parts that are insulated. If you for the blade under the work piece. accidentally cut into hidden wiring or the saw’s own cable, the metal parts of the saw will become ‘live’ . •...
  • Page 7: Know Your Product

    1. Laser light assembly 10. Shoe plate Know your product 2. Laser light on/off switch 11. Shoe lock Before using the jigsaw, familiarise yourself with all the operating features and safety requirements. 3. Laser light battery cover 12. Blade guard Use the tool and accessories only for the applications 4.
  • Page 8: Adjusting The Shoe For Angular Cutting

    Adjusting the shoe for angular cutting 2. The vacuum adapter supplied can be used to connect an ordinary household vacuum cleaner to the tool. Caution. Always ensure that the jigsaw is switched off and plug is removed from the power point before making 3.
  • Page 9: Making A Cut

    4. Position “1” denotes the lowest speed. Position “6” Cutting metal denotes the highest speed. 1. When cutting metals, a suitable cooling/cutting oil must be used. Making a cut 2. Squirt the lubricant onto the blade or work piece at 1.
  • Page 10: Changing A Blade

    Changing a blade 3. Plug in the machine and start the motor. Warning. Always ensure that the saw is switched off and 4. When the blade is at its maximum speed plug is removed from the power point before making any (approximately 2 seconds), place the saw on the work adjustments.
  • Page 11: Maintenance

    Maintenance 1. Store the tool, instruction manual and accessories in a secure place. In this way you will always have all the information and parts ready to hand. 2. Keep the tool’s air vents unclogged and clean at all times. 3.

Table of Contents