Changing Timeout Parameters; Enabling Broadband Status Notification; Enabling Missing Dsl Filter Notification; Enabling Sip Application Layer Gateway - 2Wire 2701HGV-W User Manual

f. If required, reboot the system for the changes to take effect.
Attach the computer to the Local Network port of the 2Wire gateway.
2.
In the Web browser address bar, enter 172.16.0.1/management.
3.
Click Configure Services.
4.
Click the
5. Enable Routing
Click the
6. Submit Settings
The gateway PPP , routing, and TCP/IP functions are now re-enabled, and the Local Network LED will turn
Green. The computer can now be reset to a DHCP-assigned IP address, or left to obtain it statically.

Changing Timeout Parameters

By default, TCP and UDP are configured to timeout in 1,440 and 10 minutes, respectively. You can change
the parameters by entering different values in the TCP Timeout and UDP Timeout fields, and then clicking
the button.
Submit

Enabling Broadband Status Notification

Note:
This field will display only if the CMS organization has the Broadband Status Notification
feature enabled.
To receive a notification message that the gateway has lost broadband connectivity and cannot access the
Internet, check the
Enable

Enabling Missing DSL Filter Notification

Note:
This field will display only if the CMS organization has the Missing DSL Filter Notification
feature enabled.
To receive a notification message that the gateway has detected a missing DSL filter, check the
checkbox.

Enabling SIP Application Layer Gateway

To enable the SIP ALG on the gateway firewall, check the

Changing the Upstream MTU

The MTU (Maximum Transmission Unit) is the largest size packet or frame, specified in octets (eight-byte
bits), that can be sent from a computer to the network. The 2Wire gateway's MTU varies, depending on the
connection type used (for example, PPP or direct IP).
checkbox.
button.
checkbox.
Management and Diagnostic Console
checkbox.
Enable
Enable
113