Advanced - Configure Time Services Page - 2Wire 2701HGV-W User Manual

Advanced - Configure Time Services Page

Note:
To access this page, your network must have the Remote Management feature enabled.
If the feature is not enabled, an error message will display when you click the link to access
this page.
The Advanced – Configure Time Services page allows you to view and change system time and date
settings.
Figure 47. MDC Advanced Configure Time Services Page
During the 2Wire gateway setup process, you specify the time zone in which you are located so that the
time and date are automatically displayed in the 2Wire gateway user interface. These time settings are
displayed in the Current Time Settings panel, which shows the current date, time, time zone, and whether
the time was automatically or manually configured. If you wish to manually set the time and date, you can
do so in the Manually Set Time/Date panel.
Management and Diagnostic Console
108