Advertisement
• General Problems.
• Will not record incoming
messages.
• Will not answer calls.
• Distorted outgoing message.
• Faint outgoing message.
• Noisy outgoing message
• No call screening from the base
unit.
• Cannot hear messages when
played.
• "
" flashing on the base-unit.
• Back-up batteries fail frequently.
None of the answering machine functions
will operate while the telephone is in use.
The answering machine is switched off.
The answering machine is full.
The answering machine has a very
sensitive microphone. This picks up any
background noise. If you record your
outgoing message too quietly or from too
far away the sensitivity of the microphone
increases to compensate and will pick up
more background noise.
The volume is set too low.
No back-up batteries fitted.
Back-up batteries are flat.
Back-up batteries are incorrectly fitted.
Back-up battery compartment cover off, or
not fitted correctly.
Frequent power failures will drain the
back-up batteries.
Unplugging the base unit from the power
supply drains the back-up batteries.
Switching the mains supply off will drain
the back-up batteries.
Ensure that the telephone is not in use before
operating the answering machine.
Switch the answering machine on manually or
by remote control.
Delete some or all of your messages manually
or by remote control, to make room for new
messages.
Record your outgoing message at a reasonable
volume 20cm away from the microphone in a
quiet environment.
Press and release the end of the volume control
with the larger symbol until the unit is loud
enough.
Fit back-up batteries.
Replace all back-up batteries.
Remove batteries and refit correctly.
Ensure cover is replaced correctly.
Leave the base unit plugged in, or remove the
back-up batteries before unplugging.
Do not switch off, or remove the back-up
batteries before switching off.
Advertisement
