Table of Contents
Advertisement
When dialling a number, you can enter
a pause between the digits. For example
you may need to allow time for the
phone to pick up an outside line before
calling the number you want.
Each time you press the
a 2.5-second pause is inserted into the
number you are dialling.
This lets you view the name and numbers
stored in the one-touch memory.
Press and hold the
still holding the
The display will show PROGRAM MODE.
Release the
show NO PIC.
Press the
shows READ PHONE MEM.
Press the
shows SELECT M1 TO M8.
Press the
The display shows PHONE MEMORY M1.
Press the
stored number and name. If no entry is
stored, the display shows MEMORY IS EMPTY.
Press the
return to the Program Mode menu.
Replace the handset.
12
button
button and whilst
button lift the handset.
button. The display will
button until the display
button. The display
button you want.
or
to view the
or
button to
Providing the Ring/MW1/MW2 switch has
been set to indicate message waiting, the calls
light flashes or remains permanently on when
the phone is not in use to let the user know that
they have messages.
This allows a PC, palmtop or other device to be
connected via the Converse 2015 to the
telephone network for Internet access, sending
and receiving data, faxing etc.
Plug your device into the data socket at
the back of the Converse 2015.
Use your device as normal for
connection to the Internet, faxing etc.
If the Converse 2015 is connected to two
telephone lines, Line 2 is used for data
connection and you can make and receive
phone calls at the same time.
If only one line is connected, you cannot make
phone calls while using the line for data.
Advertisement
Table of Contents
