Message Waiting; Data Port - BT Converse 2015 User Manual

To store a pause
When dialling a number, you can enter
a pause between the digits. For example
you may need to allow time for the
phone to pick up an outside line before
calling the number you want.
Each time you press the Pause button
a 2.5-second pause is inserted into the
number you are dialling.
To view a name and number in the
one-touch memory
This lets you view the name and numbers
stored in the one-touch memory.
Press and hold the
still holding the
The display will show PROGRAM MODE.
Release the
show NO PIC.
Press the Hold button until the display
shows READ PHONE MEM.
Press the Secrecy button. The display
shows SELECT M1 TO M8.
Press the M1-M8 button you want.
The display shows PHONE MEMORY M1.
Press the Volume
stored number and name. If no entry is
stored, the display shows MEMORY IS EMPTY.
Press the Hold or Redial button to
return to the Program Mode menu.
Replace the handset.
12
All manuals and user guides at all-guides.com
Converse 2015 ~ 4th Edition ~ 10th September '02 ~ 4517
#
button and whilst
#
button lift the handset.
#
button. The display will
+
–
or to view the

Message waiting

Providing the Ring/MW1/MW2 switch has
been set to indicate message waiting, the calls
light flashes or remains permanently on when
the phone is not in use to let the user know that
they have messages.

Data port

This allows a PC, palmtop or other device to be
connected via the Converse 2015 to the
telephone network for Internet access, sending
and receiving data, faxing etc.
To use the data port
Plug your device into the data socket at
the back of the Converse 2015.
Use your device as normal for
connection to the Internet, faxing etc.
Note
If the Converse 2015 is connected to two
telephone lines, Line 2 is used for data
connection and you can make and receive
phone calls at the same time.
If only one line is connected, you cannot make
phone calls while using the line for data.