Installation; Before Connection; Electrical Connection - Brandt ME250 Installation & Operating Instructions Manual

BEFORE CONNECTION

•Do not use your appliance immediately (wait approx. 1-2 hours) after transfer from a cold place to
a warm place as condensation may cause a malfunction.
• Make sure that your oven has not suffered any damage during transport (deformed door or door
seal, etc.). If you see any signs of damage, contact your dealer before use.
• Check the power voltage. If there is a PERMANENT undervoltage (200-210 volts), consult your
electrical installer.
LOCATION
• The oven is meant to be set on a work surface at least 85 cm above floor level.
• Place the oven on a flat and horizontal surface, away from any source of heat or
steam. To ensure the stability of the microwave oven, the front left foot is
adjustable (5 positions). Turn it to raise or lower the appliance.
• Make sure that air may circulate freely around the oven.
Leave sufficient space around the oven :
- 5 cm between the sides of the oven
and any walls or objects
- 14 cm above the oven
- 10 cm behind the oven.
• Make sure that nothing obstructs the ventilation ouvers at the back of the appliance.
• Make sure the electrical plug will be accessible after installation.

ELECTRICAL CONNECTION

• Your installation must be protected by a 13 Amp thermal fuse.
• It is mandatory to use a power point with a ground terminal, connected in accordance with
current safety regulations.
• In your electrical installation, provide a device that is accessible to the installer, capable of
separating the appliance from the mains power and whose contact opening is at least 3 mm
at all of the poles.
• Never operate the oven if the supply cord and/or its plug are damaged. In order to avoid any
danger, call in a specialised technician trained by the manufacturer to repair the damage.

Installation

5 cm
3
14 cm
5 cm