Programming Possibilities - Electrolux EDC 5375 Operating Instructions Manual

Programming possibilities

The electronic control system of your laundry dryer
provides you with the possibility to adapt some func-
tions of the dryer permanently to your requirements.
Purpose
"Laundry protection": If you want
to "lock" the selected drying pro-
gram (the selected program set-
ting cannot be changed during
the drying process at the pro-
gram selector or with the SPE-
CIAL CARE (SCHON) button:
When "Washing Protection" is
enabled, the drying programme
always runs at reduced heater
power (SPECIAL CARE
(SCHON.) Function).
If you always want to be
reminded by an audible signal at
the end of the program:
If you remove condensate via an
external condensate drain-off
and wish to permanently sup-
press the EMPTY WATER
(BEHÄLTER) indication:
Adjusting the drying result:
If at the end of the programme
you always want the washing to
be somewhat dryer or some-
what damper than with the
standard setting and you want to
adjust the tumble dryer's recog-
nition of the degree of dryness
accordingly:
24
When a drying program is set at the program selector and the START/PAUSE
(START/PAUSE) button has been pressed:
- Hold the SPECIAL CARE (SCHON) button depressed for five seconds.
The program execution display flashes for five seconds and the laundry pro-
tection is then switched-on.
If an attempt is nevertheless made to change the program setting, the pro-
gram execution display flashes; after pressing the SPECIAL CARE (SCHON)
button, it flashes for five seconds; on turning the program selector it flashes
until the program selector is returned to the initial setting.
To cancel the laundry protection:
- Hold the SPECIAL CARE (SCHON) button depressed for five seconds.
The program run indicator flashes for five seconds, then it is lit steady for five
seconds; laundry protection is cancelled.
1) Ensure that the program selector is not in the setting LIGHT
(BELEUCHTUNG) or OFF (AUS).
2) Hold the AUDIBLE SIGNAL (SIGNAL) button depressed for at least five
seconds.
The AUDIBLE SIGNAL (SIGNAL) display lights; a short audible signal is
sounded.
The selected setting is therewith fixed-programmed.
If you want to cancel this setting:
3) Proceed as described under item 1) and 2).
The display AUDIBLE SIGNAL (SIGNAL) disappears.
1) Set the programme selector to LIGHT (BELEUCHTUNG).
2) Hold the AUDIBLE SIGNAL (SIGNAL) button depressed for five seconds.
The PROG. TIME (LAUFZEIT) display shows U for normal function and &
for external condensate drain-off.
3) Briefly press the AUDIBLE SIGNAL (SIGNAL) button to choose between U
and & .
4) Turn the program selector.
The selected setting is therewith fixed-programmed.
1) turn the programme selector to the LIGHT (BELEUCHTUNG) position.
2) Hold down the DELAY TIMER (ZEITVORWAHL) button for five seconds.
The current setting appears in the PROGRAMME TIME (LAUFZEIT) display:
H1 is the standard setting, with
H0 the washing will be dryer, with
H2 the washing will stay damper.
3) Keep pressing the DELAY TIMER (ZEITVORWAHL) button until the value
you require appears in the display.
4) Turn the programme selector.
The selected setting is then saved.
Execution