Emerson HF948W Instructions

READ AND SAVE THESE INSTRUCTIONS
®
WARNING:
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
1. READ YOUR OWNER'S MANUAL CAREFULLY AND KEEP IT FOR FUTURE REFERENCE.
2. USE THIS UNIT ONLY IN THE MANNER INTENDED BY THE MANUFACTURER. IF YOU HAVE ANY QUESTIONS,
CONTACT THE MANUFACTURER.
3. BEFORE SERVICING OR CLEANING UNIT, SWITCH POWER OFF AT SERVICE PANEL AND LOCK SERVICE PANEL
DISCONNECTING MEANS TO PREVENT POWER FROM BEING SWITCHED ON ACCIDENTALLY. WHEN THE
SERVICE DISCONNECTING MEANS CANNOT BE LOCKED, SECURELY FASTEN A WARNING DEVICE, SUCH AS A
TAG TO THE SERVICE PANEL.
4. SUITABLE FOR USE WITH SOLID-STATE SPEED CONTROLS.
5. DO NOT BEND THE BLADE BRACKETS WHEN INSTALLING THE BLADES, BALANCING THE BLADES, OR
CLEANING THE FAN. DO NOT INSERT FOREIGN OBJECTS IN BETWEEN THE ROTATING BLADES.
WARNING:
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
1. BE SURE POWER IS TURNED OFF AT THE SERVICE PANEL BEFORE WIRING.
2. INSTALLATION WORK AND ELECTRICAL WIRING MUST BE DONE BY QUALIFIED PERSON(S) IN ACCORDANCE
WITH ALL APPLICABLE CODES AND STANDARDS, INCLUDING FIRE-RATED CONSTRUCTION.
3. ALL WIRING MUST SATISFY NATIONAL AND LOCAL ELECTRICAL CODES. THE HEAT FAN MUST BE GROUNDED
AS A PRECAUTION AGAINST POSSIBLE ELECTRICAL SHOCK.
4. THE FAN MUST BE MOUNTED WITH THE FAN BLADES AT LEAST 10 FEET FROM THE FLOOR TO PREVENT
ACCIDENTAL CONTACT WITH THE FAN BLADES.
5. SUITABLE FOR USE WITH SOLID-STATE SPEED CONTROLS.
6. ALWAYS PROPERLY CONNECT THE SECONDARY SUPPORT CABLE INCLUDED WITH THIS FAN (FOLLOW
"INSTALLATION" SECTION CAREFULLY).
7. THE SUPPORT BEAM OR JOIST MUST BE SECURE AND CAPABLE OF SUPPORTING AT LEAST 50 POUNDS.
1. Unpack the items carefully to avoid damage to any of the
components.
2. Make certain you receive the following parts:
a. Motor subassembly
b. Blades (3 ea.)
c. Upper canopy
d. Lower canopy
e. J-hook bag assembly containing:
1. J-hook (2 ea.)
2. Flat washers (2 ea.)
f. 24" Hanger pipe assembly
g. 8" Hanger pipe
Part No. F40BP71650001
10' MIN.
TO FLOOR

IMPORTANT SAFETY INSTRUCTIONS

RULES FOR SAFE INSTALLATION
Checking Contents of Package
3. Lock washers (2 ea.)
4. Hex nuts (2 ea.)
HEAT FAN
48" Model Number:
HF948W 0 (White)
SPECIFICATIONS
Model No. Power
HF948W 0 120V
Net Weight:
h. Bag of parts containing:
1. Wire connectors (3 ea.)
2. Cable clamps (2 ea.)
3. M6 x 1/2" Hex head screws (6 ea.)
4. M6 Spring washers (6 ea.)
5. Blade gaskets (3 ea.)
6. Clevis pin
7. Hairpin clip
8. 5/16-18 x 1/4" Setscrews (2 ea.)
9. Allen wrench
NOTE: Intermixing blades between fans can cause
excessive wobble. Keep blades in sets of three.
®
Amps Watts
60Hz 0.70 85
50Hz 0.47 54
18.0
Lbs.
Form No. BP7165-1
RPM
315
270