Ivr Interface - NetComm V210P User Manual

Interactive Voice Response
IVR Interface for VoIP Gateway
You can use the PSTN phone to configure the NetComm ATA. Please follow the instruction below to configure it.
Group IVR Action
Function Reboot
Function Factory Reset
Info Check IP
Address
Info Check IP Type
Info Check the
Phone Number
Info Check Network
Mask
Info Check Primary
DNS Server
Setting
Info Check IP
Address
Info Check Firmware
Version
Setting Set DHCP client #111#
Setting Set Static IP
Address
Setting Set Network
Mask
Setting Set Gateway IP
Setting Set Primary DNS
Server
Setting Set Codec
Set Handset
Gain
Set Handset
Volume
VoIP Adapter User Guide
46
IVR Menu Choice Parameter(s)
#195# None
#198# None
#120# None
#121# None
#122# None
#123# None
#125# None
#126# None
#128# None
None
#112xxx*xxx*xxx*xxx# Enter IP address
using numbers on the
telephone key pad. Use
the *(star) key when
entering a decimal point.
#113xxx*xxx*xxx*xxx#
#114xxx*xxx*xxx*xxx#
#115xxx*xxx*xxx*xxx#
#130+[1-8]# 1:G.711 u-Law, 2: G.711
a-Law, 3:G.723.1, 4:
G.729a, 5: G.726 16K,
6:G.726 24K, 7: G.726
32K, 8: G.726 40K,
#131+[00~15]# Handset Gain from 0~15 You can set the Handset gain to proper value,
#132+[00~12]# Handset Volume from
0~12
Notes:
After you hear "Option Successful," hang-up.
The system will reboot automatically.
System will automatically Reboot. WARNING:
ALL "User-Changeable" NON DEFAULT
SETTINGS WILL BE LOST! This will include
network and service provider data.
IVR will report the LAN port IP address
IVR will report the WAN Port DHCP is enabled
or disabled.
IVR will report the VoIP number in use.
IVR will report the WAN Port network mask
IVR will announce the current setting in the
Primary DNS field.
IVR will report the WAN port IP address
IVR will announce the version of the firmware
running on the VoIP Gateway.
The system will change to DHCP client type
DHCP will be disabled and system will change
to the Static IP type.
Must set Static IP first.
Must set Static IP first.
Must set Static IP first.
You can set the codec you want to the first
priority.
default is 6
You can set the Handset volume to proper
value, default is 10
YMLV21046 YMLV21046 V21046
www.netcomm.com.au